[GUEST ACCESS MODE: Data is scrambled or limited to provide examples. Make requests using your API key to unlock full data. Check https://lunarcrush.ai/auth for authentication information.]
@bears0 ThinkThenDont
ThinkThenDont posts on X about crystal, ldo, vr, the only the most. They currently have XXX followers and XX posts still getting attention that total XX engagements in the last XX hours.
Engagements: XX #
- X Week XXX -XX%
Mentions: X #
- X Week X +25%
Followers: XXX #
- X Week XXX -XXXX%
CreatorRank: undefined #
Social Influence #
Social topic influence crystal, ldo, vr, the only
Top Social Posts #
Top posts by engagements in the last XX hours
"@advancedlong @MehdiHacks Im not sure why I thought that crystal was a USB-C port at first lol"
X Link @bears0 2025-10-16T01:02Z XXX followers, XX engagements
"@JackShandy5 @bubblebabyboi They will if theyre programming embedded systems"
X Link @bears0 2025-10-14T21:48Z XXX followers, XXX engagements
"I was referring to using them to power more current hungry devices. I thought buck converters operated around 80-95% efficiency though. I can understand why an LDO would be better for low power low cost devices but are you saying that buck converters arent efficient with low power devices Ive only seen the efficiency charts go down to mA ranges e.g"
X Link @bears0 2025-10-14T21:40Z XXX followers, XX engagements
"Sorry thats not true. I = V/R. If you have an air core inductor with a 1in diameter thats 3.14159e6 in of wire. Approximately 80km. 0.5mm2 wire is about XXXX Ohms/km. Total of 2760 ohms. 10V would give you about 3.4mA. The magnetic field is proportional to current so you will definitely have a magnetic field. The only time you can have voltage on a load with no current* is with a diode in reverse polarity. (Theres a small amount of leakage current but its mostly negligible. It basically becomes a very high resistance until you hit the threshold voltage)"
X Link @bears0 2025-10-16T04:57Z XXX followers, XX engagements